Dies after turning over.
Well just got my G6 about a month ago and when I got it I noticed the ignition wire running from the MAF Sensor was cut. I replaced the connector and soldered it all nice and pretty and now it starts and runs much better, but sometimes when the engine has warmed up it still will die after turning over. It will turn over fine and run for about one second and then stutter out. If I try starting it again, it will turn over fast until i tap the gas to give it a little air. Any ideas? I was hoping that the computer would recognize the new connection and sooner or later be able to start up no problem but it continues to have the warm starting problem. No SES but it does have SVS...any places that can check these SVS codes? Thanks!