Pontiac G6 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I picked up a 2009.5 G6 and the power lift function is broken. It works but there is a tear in the seat close to the lumber lever and when I activate the switch to lift the seat, a metal bracket comes up through the hole in the seat. Any ideas how to fix this? I will have to dig into it and take it out of the car but figured I would see if this is common.
 

·
Registered
Joined
·
215 Posts
That sounds like the seat frame is broken somewhere.
Look underneath as you use the switches to go up or down, you should have parallel movement.
You might me able to have it welded, but you have to strip it first. If you have skills, it isn't that bad. If not, it might be best to swap with a known good seat.

Sent from my XT1635-01 using Tapatalk
 
1 - 2 of 2 Posts
Top