Pontiac G6 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Well I ran into a set back- I just noticed that my RPM and Speed Sense is ran through Data from the ECM, so essentially the wires I was going to tap into aren't at the cluster- however as for a write up- there is one out there already that is everything you would need to know and he describes it pretty in depth- its on a VWvortex forum. I however and going to design/ redesign my own PCB- (circuit board) and make it an aftermarket plug in, with LeD rings that you place behind the speedometer. It'll take awhile! But I will def show it when I'm done.
did this ever get finished?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top