Pontiac G6 Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
485 Posts
Discussion Starter · #1 ·
Forget about it! I attempted this today, got about 4 inches of it off, and found that GM drilled holes in the door. And on the molding there are plastic 'nipples' that fit into these holes, I guess for aligning them on the doors. So unless you plan on filling in the holes, however many there are, and repainting the door, don't bother trying to remove the moldings. Too bad, the car would look so much sleeker and cleaner without them.

Mike
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top