Pontiac G6 Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
73 Posts
Assuming someone makes a gas cap that locks for the G6, why not just make the tether?

Usually the caps are plastic, and the shroud around the filler neck is plastic. Drill a small hole in the cap and one in the shround, then rivet a strip of plastic, at each end (wire tie or something similar) and voila!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top