Pontiac G6 Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1 (Edited)
My other ride - 97 Accord

My other car is a 97 Accord. Already swapped with a JDM H22a and 5 speed. I have about everything to rebuild the engine and boost it except for sleeves. Quite a bit dine to it, but also quite a bit to do. I have boxes with parts to install, and hope to start on it again now that it's getting nice again. I'll post pictures later.
 

·
Registered
Joined
·
37 Posts
Discussion Starter #8
LIST OF MODS EXTERIOR
Mugen full lip kit (front installed)
SiR folding mirrors INSTALLED
SiR window visors INSTALLED
SiR rear garnishes INSTALLED
SiR Stanley amber side markers
SiR Cornering lights
SiR bumper pole
94-95 OEM grille (no Honda badge)
INTERIOR
SiR center console with slide out cup holders
ENGINE
JDM H22a comeplete swap
Turbonetics 60-1 P-Trim .81ar T4 Turbo NOT INSTALLED
Tial 38mm wastegate NOT INSTALLLED
Greddy Type R blow off valve NOT INSTALLED NOT INSTALLED
Sparks Racing T4 turbo manifold NOT INSTALLED
HKS Type 1 turbo timer NOT INSTALLED
Skunk2 Racing intake manifold INSTALLED
Hondata intake manifold gasket INSTALLED
AEM TruPower Pulley set INSTALLED
AEM TruTime adjustable cam gears INSTALLED
AEM High Volume Fuel Rail INSTALLED
AEM Fuel Regulator INSTALLED
CP 9:1 Pistons NOT INSTALLED
Crower turbo cams NOT INSTALLED
Eagle ESP rods NOT INSTALLED
KMS dual valve springs NOT INSTALLED
KMS titanium retainers NOT INSTALLED
MSD SCI Ignition INSTALLED
MSD Blaster 2 coil INSTALLED
NGK spark plug wires INSTALLED
NGK Iridium plugs INSTALLED
EXHAUST
Apex'i World Sport exhaust INSTALLED
4-1 Header INSTALLED
STEREO
Pioneer DEH-6500 headunit
Infinity 6012si 6½" mids in door panels
Alpine 6137ax 3½" tweeters in doors
Fosgate FRC3205 5¼" mids in Q-Logic Q forms
Kicker R13 1" tweeters in Q-Logic Q forms
Q Logic QForms QL-K6004B43
PolkMOMO MMC650 6½" mids in rear deck
Sony XEC-1000 controlling signals
Stinger HFM I/O wire and Pro Series connections
Fosgate RFD2210 HX2 10" subs
Audio Enhancers PSN250 Pro Series box
Xtant X604e
Xtant X1001e
SUSPENSION
Energy Suspension hyper-flex bushing set
Tokico HP shocks/struts
Megan Racing rear lower tie bar
Vortex Racing front upper strut bar
LIGHTING
Black housing headlights
HID 9006 kit
OEM foglights
Silver Star high beams
PIAA Extreme white 7440 reverse bulbs
PIAA Mirror orange 7440 turn signal bulbs
OEM tail lights with amber removed
(Mirror orange bulbs appear clear and light up amber. No amber is seen in tails.)
SiR cornering lights
SiR sidemarkers
FUTURE MODS
Sleeve/assemble block, Cometic gasket, port & polish, paint block, Darton MID sleeves, Supertech valves, ARP headstuds, OEM Honda waterpump and other misc parts.
Hondata S300 and chipped P28 Tuned
Suspension Techniques front and rear sway bars
ESP Race traction bar
Install turbo, intercoller/piping
Quaife LSD
Tint windows $150
Rear disc conversion install (Have all the parts)
Rotor over Hub conversion with bigger rotors (all factory parts)
Braided brake lines
ESP motor mounts
H23 Auto-manual tensioner conversion
 

·
Registered
Joined
·
37 Posts
Discussion Starter #10
I was told 400-500 was obtainable with this setup. I would be extremely happy with anything over 400. Anything actually will be fine. I would run high psi for a dyno, but not sure what I would run daily 10-15? I still have a ways to go, but I bought a lot if stuff on sale and from guys that needed cash in preparation for this.
 
1 - 13 of 13 Posts
Top