Pontiac G6 Forum banner
1 - 6 of 6 Posts

· Premium Member
Joined
·
5,786 Posts
Installed molded flaps front and back

The front is a tad harder. You have to bend them into place.
Or at least I had to.

Remove the hex screw again and take out the next two push pins.
There are metal screw plates that install under the plastic and you replace the pins with screws. You have to drill for the screw on the bottom again.

Then your done. I like the effect but my Wife couldnt even tell what I did!!
aarrrrgggggggggggggggggggggg


You need to jack it up and remove the wheels.
Use a jack stand on the front as the place to support the jack
is to the rear of the tire and is in the way for the install.
So jack it up then put a stand under te rail and move the jack for the
front.

I like it.

Installed locking lugs as well.

Now I must think of my next mod.....
I believe I will paint the calipers and parts behind the wheel....now that
I have gotten a good look at them. Mine are already rusting!!!


Anyway.....took awhile to install but it wasnt complicated.

Here ia apix of the front ones
 

Attachments

1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top