Wiring Harness

in the front door or rear ? i replaced my back speakers about 2 hrs ago... with some Polk Momo MMC690's i found that 4 wires go to each rear speaker and the 2 go to the sub one is green with a black line and the other is blue with a white line. which is pos or neg i do not know. the other 2 go to the tweeters or mid speaker that sat on top of the 6X9. those wires are are both solid blue one lighter than the other .. this on on my back passenger side then on the drivers side the wires are completely different colors .. the sub wires are the same colors but the other top speakers colors were white and brown.. in all of this i don't know what wire are pos and neg but they sound good.. im going to try a different way of wiring it tomorrow and i will post my results then .. by the way i have an 06 GTP Silver with the Monsoon

Figured It Out

Ok so today I went out and installed the Jensen VM9410 indash DVD player. I did not want to go and have to spend 130 bucks on the kit to preserve the lcd screen to show me my mpg and ect. The entire install cost me $35. The wiring took some time to figure out but here it is...
LF Speaker (+)Tan (-)Gray
RF Speaker (+)Light Green (-)Dark Green
LR Speaker (+)Brown (-)Yellow
RR Speaker (+)Dark Blue (-)Light Blue
12v Constant - Thick red wire
12v Ignition - ran from fuse box HVAC (ign.)
Ground - Thick black wire

To make the dvd player play all the time I hooked the parking brake wire to ground. This worked great and the only features that the car is missing is what would have been displayed on radio display. The door chime, dome light, remote entry, and everything else works perfectly.

This was done on an 06 pontiac g6 without the monsoon radio.

Do you think it would be the same on the monsoon ? back to my polk momo's I installed .. i ended up hooking a Jensen 500W to them using the power wire from the exhisting amp in the back passenger side of the trunk then i grounded it to the back seat frame.. then used hi imputs.. then just wired the speakers from there...i only hooked up the Subs' on the Jensen .. I used the factory amp for the tweeters and mid on the polk ... sounds good... then instead of replacing the factory 6 1/2 in the driver and passenger door's.. I added 2 6 1/2 Focal polyglass to my passenger doors.. so now my system has Focal tweeter's in the front.. Factory 6 1/2 in the driver and passenger doors... then the back 2 doors have the 6 1/2 Focal's also i wired them off my 500w Jensen.. and then in the back the Polk MoMo mmc690's what ya think >? and i still am using the Monsoon Head unit... IT sounds awesome I just need to find a remote wire to use for the Amp ... are there any factory wires in the trunk vacinity that could be used for a remote wire ?